6.1.4 Adjustment of the height of the milling cutter pack 4
Repeat the above described operations from point 1 to point 8 (setting milling cutter 4).
21) Use the 17 mm wrench to loosen the nut with ref. 2
(DWG. A1.27)
.
22) By means of the 5 mm Allen wrench (supplied with the machine) adjust the screw with
ref. 1
(DWG. A1.27)
(the milling cutter goes down as the screw is tightened and goes
up as the screw is loosened).
23) At the end of the adjustment tighten the nut 2.
DWG. A1.27
6.2 Adjust of the milling depth
The corner cleaning machine type CM4-S has a device permitting to adjust the milling depth
independently for each single milling cutter group.
(DWG. A1.28)
The machine is regulated by PERTICI SPA in such a way that the 80 mm guide disc has a
milling depth of 2 mm with respect to the theoretical angle root (whose two external surfaces
rest on the positioning shoulders).
In the following pages we indicate the 4 screws to carry out a further adjustment for each single
milling cutter pack (to carry our this operation and to accede to this device, it is necessary to
remove the lateral lower panel on the left of the base plate).
MANUALE D’ISTRUZIONE PER L’USO E LA
MANUTENZIONE PULITRICE AUTOMATICA CM4S
33
File: 2240.doc - 03/11/03 14:27
