6. ADJUSTMENTS FOR TOOLS OPERATIONS
IMPORTANT! ALL OPERATIONS DESCRIBED IN THIS CHAPTER MUST BE CARRIED OUT
BY AUTHORISED PERSONNEL, WHICH MUST STRICTLY OBSERVE THE INDICATED
PROCEDURE.
6.1 Adjustment of milling cutter packs height
The corner cleaning machine type CM4-S can host up to 4 milling cutter packs (with a 97 mm
height each) mounted at the same time (one upon the other) on the milling cutter holding shaft.
If there are less than four milling cutters installed, relevant spacers must be mounted to reach
the height of four milling cutters anyway (97 mm x 4).
In the following sections we explain the procedure for the height adjustment of the milling cutter
packs.
6.1.1 Adjustment of the height of the milling cutter pack 3
If the machine uses all 4 milling cutter packs, it is necessary to start the adjustment from group
No. 3 (the third starting from the top) otherwise observe the following indications valid for groups
1 and 2 and 4.
1) Turn the machine on and act on key RESET. The display shows:
F1 UPP. CUT. DEV.ON
F2 LOW. CUT. DEV.ON
F3 MILL. CUTT. MAN
SET MILL. CUT.:1
2) In case the milling cutter has been set to “AUTO” or to “OFF” act many times on F3 to
enter “MAN”
3) Press 3 to enter the position of the third milling cutter.
4) Enter an angle to be polished and wait for the machine to block the piece and position
the milling cutters vertically.
5) As soon as the milling cutter starts approaching to the piece, press the emergency push
button to lock the cycle.
6) Close the disconnecting slide valve of the pneumatic circuit (Picture 3)
7) Turn the main section switch to position 0
8) Open the upper right panel. The lower side of the milling cutter 3 is near the lower side of
the profile.
To verify this alignment, it is possible to move by hand the milling cutter carriage to bring it close
to the angle to be polished.
MANUALE D’ISTRUZIONE PER L’USO E LA
MANUTENZIONE PULITRICE AUTOMATICA CM4S
30
File: 2240.doc - 03/11/03 14:27
