PerkinElmer OilExpress System, Руководство пользователя

Страница: 84 / 102

84 . OilExpress System User's Guide
Lubrication
The Autosampler does not require lubrication under normal operating conditions. If the
lubricant applied at the factory should be wiped away or if the X/Y axis guide rails become
dirty, cleaning and lubrication is necessary. Follow the instructions below when applying
lubricants.
1. Turn off the power to the Autosampler.
2. Move the arm to the far right side of the X-frame.
3. Clean the X-axis guide rails using a lint-free cloth and isopropyl alcohol.
4. While moving the arm to the left side of the X-frame, clean the three roller bearings
mounted to the base of the X-slide.
5. Wipe the section of the X-axis guide rail that was covered by the arm.
6. Using a fingertip, apply a thin film of lubricant to both X-axis guide rails.
7. If the Y-axis guide rails are dirty, follow steps 2 through 6.
Changing the Autosampler Fuses
Two 5A fuses are fitted to the Autosampler.
1. Switch off the Autosampler and disconnect the mains electrical supply.
2. Disconnect the mains electrical supply lead from the side of the Autosampler.
3. Insert a small screwdriver into the slot above the fuse drawer and lever the fuse drawer
out.
4. Remove both fuses from the fuse drawer.
NOTE: If a fuse blows, it is recommended that both fuses be replaced.
5. Fit the replacement fuses.
6. Push the fuse drawer back into the Autosampler, and switch on the Autosampler.
WARNING
For continued protection against risk of fire, only replace fuses which
meet the following specified types and current rating.
The following fuse must be used when operating the Autosampler:
Name Location Type
Main Fuse Power Entry Module T5.0 A/250 V × 2