PerkinElmer OilExpress System, Руководство пользователя

Страница: 41 / 102

Unpacking and Installation . 41
8. Inspect instrument for any physical damage.
9. Open the box of accessories and place the contents on an open surface.
10. Check to make sure that all parts have been received.
NOTE: If any parts are missing from the packing list, contact PerkinElmer immediately.
Unpacking and Installing the Sample Shuttle
The sample shuttle accessory can be simply installed into the sample compartment of the
spectrometer.
1. Unpack the sample shuttle from its box.
2. Rest the back of the sample shuttle accessory on the ledge in the sample area and slide
it into position.
Push it firmly home to ensure that the multiway connector on the rear of the sample
shuttle accessory mates properly with the spectrometer connector.
Figure 14 Installing the sample shuttle accessory
NOTE: To remove the sample shuttle accessory, release the accessory by pulling the blue
handle under its baseplate, and then slide the accessory towards you and out of the
sample compartment.
WARNING
When the sample shuttle locks into place it aligns itself, which means
that the slide holder may move. Be careful that your fingers, tie, etc are
not trapped by the movement.