PCAN-Router Pro FD – User Manual
17
Figure 8: Positions of the transceiver modules for the six CAN FD channels
Attention!
Electrostatic discharge (ESD) can damage or destroy
components on the card. Take precautions to avoid ESD.
Do the following to change a transceiver module:
1.
Disconnect the device from the power supply.
2.
Remove the two upper screws on the front and rear of the
housing.
3.
Pull the housing cover upwards.
4.
Only with backup battery installed:
Remove the backup battery.
5.
Remove the screw on the board from the transceiver
module to be replaced.
6.
Remove the module from slot of the front panel.
7.
Plug the new transceiver module into the slot.
8.
Fasten the module with the screw.
9.
Only with backup battery installed:
Reinstall the backup battery and secure it with a cable tie.
10.
Put the housing cover back in place.
11.
Fasten the four screws to the front and rear of the housing.
