30
executing this command, the results are displayed analogously to the Manual or
spontaneous Potential type sessions, therefore refer to paragraph
the only difference is that the command of Execute /
Modify a measurement is not active.
The Run Session command allows to carry out the measures envisaged for the automatic
session (see paragraph
Perform the measurements of an automatic session
Perform the measurements of an automatic session
After the request to execute an automatic measurement, the operator is asked to select the
sorting of the measurement lines or to confirm the default. The system considers that the
electrodes have dispositions from 1 to 16 for the first 26, and from 17 to 32 for the second
sixteen; if the arrangement is reversed, the operator has the possibility to overturn the
arrangement for one or both groups of electrodes.
F
IGURE
22
-
PARAMETERS
OF
AN
AUTOMATIC
SESSION,
FIRST
PART
F
IGURE
23
-
PARAMETERS
OF
AN
AUTOMATIC
SESSION,
SECOND
PART
Содержание GEA RM1 1.0
