GEA RM1
39
Description of the systems interface in standalone mode
Measurements configuration
The measurement configuration menu allows you to configure the values of some
parameters used by the system to make the measurements.
These parameters are shown below.
-> Maximum Sigma: determines the mean square deviation value as a percentage of the
value of the measurement at which the system will assume the obtained value as
sufficient, and will not carry out further measurement repetitions.
-> Maximum number of cycles: defines the maximum number of cycles to be performed
for a measurement, when this number of cycles is reached, the measurement will still be
terminated, even if the maximum Sigma value has not been reached.
-> Max V (A-B):
-> Max I (A-B):
- - Default parameters: through this command it is possible to configure all the parameters
to the factory default values.
By executing the commands you get the screens on which the minimum, maximum and
default values are displayed for each of the parameters, by commanding the variation of
the value, you can enter the chosen value.
F
IGURE
32
-
MEASURE CONFIGURATION
Содержание GEA RM1 1.0
