PASI GEA RM1 1.0, Руководство пользователя

Страница: 45 / 71

GEA RM1 41
Description of the systems interface in standalone mode
-> Display format of the geometry values for the sessions: you can pick the complete
display of the geometric data of the electrodes or the simplified view when possible can
be selected. See section Simplified display of geometric measurement data for further
information on the subject.
-> Linear measurement unit: meters or yards can be chosen. The chosen linear unit of
measure also applies to all the derived quantities, then to K and to Rho (which will be
reported as Ohm * m or Ohm * yd). It affects only the view modes and not the format
within the GPD file stored on the session measurements.
-> Name of electrodes: the names A, B, M and N or the names C1, C2, P1 and P2 can be
chosen. It only affects the view modes and not the format within the GPD file, where the
electrodes are stored as A, B, M and N.
Information about the system components is also viewed. This information is listed
below.
- Serial number of the Gea RM1 system.
- Library version.
- Firmware version.
- Hardware version.
-> Clear memory: this allows you to delete all the sessions and measurement templates
on the systems memory.
Switching off the system
The Gea RM1 system can be switched off using the "System Shutdown" command button
on the main menu. Switching off the system in this way, all the data processed will be
correctly saved on the permanent memory of the system.
The system can also be switched off by keeping the "Esc" button pressed for a few
seconds or by removing the power cable from the system, but in this case the data that
has not yet been saved by the system on the permanent memory may be lost, so we
strongly recommend you not to use this procedure.