Parker Coral Sea, Руководство пользователя

Страница: 103 / 248

[ CONTROL SYSTEM OPERATIONS MANUAL ]
May, 2015
Project: Doc: Version:
Parker Sea Recovery Coral Sea 1010016 01c
Document Name: Author: Page:
Control System Operations Manual AGE Page 67 of 129
19
PT-1000 Sensor Malfunction.
Start-Up Aborted **
Pressure transducer PT-1000 is reporting a fault.
Check the system messaging area for help diagnosing
the type of failure detected, and rectify before
continuing
20
PT-1008 Sensor Malfunction.
Start-Up Aborted **
Pressure transducer PT-1008 is reporting a fault.
Check the system messaging area for help diagnosing
the type of failure detected, and rectify before
continuing
21
HP Pump Outlet Pressure Too
High. Start-Up Aborted
The outlet pressure of the high pressure pump was
driven too high; this caused the control system to
shutdown the unit. Run the system at pressures below
maximum (975 PSI)
22
HP Sensor Overridden When HP
Switch Detected Fault
The system was operating in emergency mode (PT-
1005 By-passed) when the high pressure switch
detected an over pressure situation. Check system
pressures and ensure they are below maximum.
23
High Pressure Sensor Override
Time Limit Reached
The system was operating in emergency mode (PT-
1005 By-passed) for the maximum allowable time
(100hrs). Replace the by-passed sensor before
continuing, or contact PSRC for further help.
24
Membrane Outlet Pressure Too
High. Start-Up Aborted
The outlet pressure of the membrane chain was
driven too high; this caused the control system to
shutdown the unit. Run the system at pressures below
maximum (975 PSI)
25
Feed Pump Did Not Respond To
Auto run Command
Auto-start attempted to start the feed pump but for
some reason the pump did not start, check system
contactors and overloads for fault indication
26
Booster Pump Did Not Respond To
Auto run Command
Auto-start attempted to start the booster pump but
for some reason the pump did not start, check system
contactors and overloads for fault indication
27
HP Pump Inlet Pressure Too Low.
Start-Up Aborted
Auto-start could not start the high pressure pump
because inlet pressures to the pump did not reach
required values. Check the system filtration chain for
clogged filters, backwash the sand filter if required
Coral Sea Owner's Manual