Panasonic Minas A4 Series, Инструкция по эксплуатации

Страница: 228 / 366

226
Position loop gain : 20
Velocity loop gain : 100
Time constant of
V-loop integration
: 50
Velocity loop feed forward : 0
Inertia ratio
: 100
Position loop gain : 100
Velocity loop gain : 50
Time constant of
V-loop integration
: 50
Velocity loop feed forward : 0
Inertia ratio
: 100
Position loop gain : 100
Velocity loop gain : 50
Time constant of
V-loop integration
: 50
Velocity loop feed forward : 500
Inertia ratio
: 100
+2000
-
2000
0
0.0 375 250 125 0.0 375 250 125 0.0 375 250 125
[r/min]
Command Speed
Motor actual speed
Gain setup : Low Gain setup : High Gain setup : High + feed forward setup
Purpose
It is required for the servo driver to run the motor in least time delay and as faithful as possible against the
commands from the host controller. You can make a gain adjustment so that you can run the motor as
closely as possible to the commands and obtain the optimum performance of the machine.
<e.g. : Ball screw>
Procedures
Start adjustment
Automatic
adjustment ?
Ready for
command
input ?
Auto-adjustment
of stiffness ?
Action O.K.?
Action O.K.?
Yes
Yes
Action O.K.?
Real time
auto-gain tuning
(Default)
Normal mode
auto-gain tuning
Release of
auto-adjusting
function
Fit-gain function
Release of
auto- adjusting
function
Manual gain tuning
Gain automatic
setup function
Finish adjustment
Writing to EEPROM
Consult to authorized dealer
(see P.228)
(see P.231)
(see P.239)
(see P.236)
(see P.248)
(see P.239)
(see P.240)
Use the
gain setup of auto-
adjustment ?
No
No
Yes
No
No
Yes
No
No
Yes
Yes
No
Yes
Gain Adjustment