Panasonic LP-RF Series, Руководство по установке и обслуживанию

Страница: 132 / 218

132
5-3-2 Communication settings
Item Ethernet communication settings
Communication protocol TCP/IP
Standards IEEE802.3 (10BASE-T) / IEEE802.3u (100BASE-TX)
Applicable cable Category 5 or higher
Applicable HUB (or rooter) 10BASE-T / 100BASE-TX compatible
IP address 1.0.0.0 to 223.255.255.255 * (Initial value: 192.168.1.5)
Subnet mask 128.0.0.0 to 255.255.255.254 (Initial value: 255.255.255.0)
Default gateway 1.0.0.0 to 223.255.255.255 * (Initial value: 0.0.0.0 (Unspecified))
PC configuration software port 1025 to 65534, except 9090 (Initial value: 9093)
Command communication port 1025 to 65534, except 9090 (Initial value: 9094)
* Do not use “127” in the first octet.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• The communication control of the laser marker through the Ethernet should be performed in a secure network settings.
• Even the IP Address and Subnet Mask values are within the configurable range, they may not be available depending
on the combination.
• For the details of the communication settings, refer to “3-4-3 General settings before external control” (P.77).
⿎
Ethernet communication settings for communication command control
Item Ethernet communication settings
Start code * ON (STX) / OFF (initial setting: STX)
Response data command * ON / OFF (initial setting: ON)
Response data sub
command *
Any single byte character of ASCII code from 01 (HEX) to 7F (HEX) can be specified.
• Initial setting of positive response code: A
• Initial setting of negative response code: E
• Initial setting of read request response code: A
Character code ASCII code
Encoding for non-ASCII
characters *
Shift-JIS / GB 2312 / Latin-1 (initial setting: Shift-JIS)
Check sum OFF
End code CR
Reception timer Timeout monitoring ON (10 sec.)
* If you set “LP-400/V compatibility” in the system settings of Laser Marker NAVI smart, the same command format
with the former models of LP-400/LP-V series is applied regardless these settings. For the details, refer to the “Serial
Communication Command Guide: LP-400/V compatible mode”.
ME-LPRF-SM-11