Panasonic LP-RF Series, Руководство по установке и обслуживанию

Страница: 113 / 218

113
4-6-6 On-the-fly marking: Marking at regular intervals
T2 T3 T3
T1
T4 T4 T4
T5
*1
ON (Open)
OFF (Close)
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
SHUTTER OPEN OUT
(No.39)
READY OUT (Y5)
TRIGGER IN (X5)
PROCESSING OUT (Y10)
LASING OUT (No.40)
PROCESSING END OUT
(Y11)
*1 : If TRIGGER IN (X5) turns off when the trigger processing operation is running, on-the-fly marking at regular intervals
is terminated after finishing the running operation.
Item Time Remarks
T1 ― Time for marking data creation. It varies depending on the quantity of the setting data.
T2 ― Time from when TRIGGER IN (X5) is turned on till when the work piece comes to the
preset marking position.
T3 ― Time it takes the workpiece to move to the setting intervals [mm].
T4 2 to 510ms This is the output to notify that the marking trigger processing completed normally. This is
One-shot output. Set the output time on System settings screen. There is a small margin of
error for the setting value.
T5 ― Time for marking data creation.
When the next marking data is not ready during the marking operation, this is the rest time
for data creation.
When the next marking data is ready during the marking operation, this takes less than
1ms.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• If the counter is reset during on-the-fly marking operation, there is a case that the next marking could not be executed
due to Warning E751.
ME-LPRF-SM-11