“slave 2” is added in lower right of “slave 1” if click “OK”.
Initial asterisk (
＊
) of name means that it is not reflected to master unit. (2) after name means Unit
No. 2. Sharp (
＃
) indicates that terminal is not set. (After entering terminal,
＃
is cleared and after
completing transfer to master and transfer from master,
＊
is cleared.)
Upper slave works as repeater for lower slave.
In this case, “slave 1” has repeater function to “slave 2”.
Therefore, upper slave can transfer data to both a terminal connected itself and another slave.
(7) Add another slave to master.
Click one master in routing table as same as (5), and select “Routing Setting” -> “Slave Unit Setup”
-> “New”.
It is added as below.
Adding slaves by this way makes 1:N topology system.
At 1:N topology, only slaves’ routing setting is not enough to specify a terminal is connected to
which slave. Deciding a relation of terminal equipment and slave makes master communicate to
terminal automatically.
Create new terminal equipment
(8) Register terminal equipment to a slave.
Click one slave that is connected to terminal equipment in routing table and select “Routing setting”
-> “Terminal Setup” -> “New”.
Input terminal’s Unit No. and name.
Input Unit No. that is specified to communicate with the upper level protocol. Select from 01 to 254.
F
or naming, it is possible to use alphabet and numbers up to 8 letters.
5-14
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: [email protected]
Содержание KR20
Страница 1: ...Phone 800 894 0412 Fax 888 723 4773 Web www ctiautomation net Email info ctiautomation net ...
Страница 4: ...Phone 800 894 0412 Fax 888 723 4773 Web www ctiautomation net Email info ctiautomation net ...
Страница 10: ...1 6 Phone 800 894 0412 Fax 888 723 4773 Web www ctiautomation net Email info ctiautomation net ...
Страница 117: ...9 1 Chapter 9 Specifications Phone 800 894 0412 Fax 888 723 4773 Web www ctiautomation net Email info ctiautomation net ...
