Scan Tool User Guide
13
2: Setup
Provide Power to Scan Tool
Before using the scan tool, you must provide power
to the scan tool. There are three methods for provid-
ing power to the scan tool:
•
AC/DC external power adapter
•
Cable connection to vehicle
•
Internal battery pack
During vehicle testing, power for the scan tool is
usually provided through the vehicle cable connec-
tion. (Therefore, it is not necessary to have the
internal battery pack fully charged before testing.)
When the scan tool is not connected to a vehicle, the
scan tool can be powered with an AC/DC external
power adapter (OTC P/N 3421-04) or the internal
rechargeable battery pack (OTC P/N 239180).
Figure 2.1: Power Adapter and Scan Tool Power Port
Battery Fast Charge
The Scan Tool battery fast charge recharges the 9.6
volt Nickel Metal Hydrate (NiMH) battery in 3 hours.
1
Plug the 12-volt Battery Charger into a 120-volt wall
outlet.
2
Plug the Battery Charger connector into the External
Power Port located on the top of the Scan Tool, see
Figure 2.1
. The battery is fully charged in 3 hours.
IMPORTANT: For maximum battery life, do not leave
the charger connected more than 12 hours.
Connect the Hardware Module
(optional)
If using the InfoTech/Scope, or Gas M-P software
applications, you must first connect the hardware
module to the scan tool. Use the following steps to
connect a hardware module.
IMPORTANT: Turn off scan tool before connecting
or removing hardware module. Failure to do so may
cause internal damage not covered by warranty.
1
Press the tool
On/Off
button to turn the power off.
2
Position the scan tool to access the back side, then
open the protective HIP door.
3
Slide the locking bars out on the hardware module
(you may need to hold them out).
4
Position the hardware module with the hardware
interface ports aligned.
5
Place the module into the compartment and press it
into place.
Item 1
Locking Bars
Item 2
Hardware Module
Item 3
Hardware Interface Port Door (shown open)
Item 4
Hardware Interface Port
Figure 2.2: Hardware Module Connection
6
Slide the locking bars in to lock the module in place.
NOTE:
To remove the module, slide the locking bars out
and pull the module upward. Close the HIP door.
4
3
1
2
Содержание Genisys EVO
