Ossila Slot-Die Coater
User Manual
Ossila.com
15
Ossila Limited © 2019
7.2
Repair & Service
Periodically, the rail guide and the lead screw should be lubricated with synthetic grease or
oil to ensure smooth motion. Repairs or servicing not covered in this manual should not be
performed. Contact Ossila if you have issues with your system.
8.
Installation
The following procedure should be followed when setting up the unit for the first time.
1.
Place the unit on a solid, level surface. If necessary, the feet can be rotated to adjust their
height and level the unit. Ensure the area is free from vibrations, temperature extremes and
highly flammable or explosive materials. Keep the area surrounding the machine clear, with
approximately 1 m clearance above the machine and around 30 cm clearance on the sides.
2.
Remove the cable ties that secure the gantry during shipping.
3.
Before plugging in the Slot-Die Coater, ensure the power switch on the unit is switched to
the ‘0’ position (off).
4.
Connect the power supply connector to the Slot-Die Coater (shown in
Figure 8.1
).
5.
Insert one LR44 battery into each digital height gauge
by removing the cap (shown in
Figure
8.2
).
6.
You may wish to turn the digital height gauges off when not in use to conserve battery life.
This is done
by pressing the ‘OFF/ON’ button.
The digital height gauges are not powered or
charged by the mains supply.
