Oracle sparc M5-32, Руководство по установке

Страница: 162 / 182

152 SPARC M5-32 and SPARC M6-32 Servers Installation Guide • December 2014
5. Verify that you have set the network addresses correctly.
For brevity, this example shows only the output for the IP address property.
Note –
After setting the IP addresses, you must type the
set /SP/network
commitpending=true
command at the Oracle ILOM prompt before the new
addresses to take affect.
6. Display the IP addresses to confirm that they have been updated.
7. Continue the installation by specifying the altitude of the server.
See “Set the Altitude of the Server” on page 153 .
Related Information
■
“Planning Network Addresses” on page 59
■
Oracle ILOM documentation
(http://www.oracle.com/goto/ILOM/docs)
-> show /SP/network -level 2 -output table pendingipaddress pendingipnetmask
pendingipgateway
/SP/network -level 2 -output table pendingipaddress pendingipnetmask
pendingipgateway
Target | Property | Value
--------------------+------------------------+------------------
/SP/network/ | pendingipaddress | xxx.xxx.xxx.xxx
ACTIVE_SP | |
/SP/network/HOST0 | pendingipaddress | xxx.xxx.xxx.xxx
/SP/network/HOST1 | pendingipaddress | xxx.xxx.xxx.xxx
/SP/network/HOST2 | pendingipaddress | xxx.xxx.xxx.xxx
/SP/network/HOST3 | pendingipaddress | xxx.xxx.xxx.xxx
/SP/network/SP0 | pendingipaddress | xxx.xxx.xxx.xxx
/SP/network/SP1 | pendingipaddress | xxx.xxx.xxx.xxx
. . . . . . .
->
-> show /SP/network -level 2 -output table ipaddress ipnetmask ipgateway