Opex FalconV, Руководство пользователя

Страница: 65 / 130

Operation 65
FalconV User Manual - Standard Scanning - OPEX Corporation
The machine will scan the item and place a thumbnail of the image in the
set window. A large image of the item will appear in the Preview window.
3 Continue to place the items you want to scan onto the conveyor. The
scanner will scan and sort the items depending on the job parameters.
As the scanner processes items, check to make sure:
• Items are being scanned properly.
• All critical information (MICR line, OCR line, etc.) is being collected
properly.
• Items are being sorted to the correct bin.
Stack Feeding
Stacks of paper (approximately 1.1 inches) can be placed on the conveyor.
The conveyor rollers will carry the stack (or packet) over to the packet feeder
where the top piece will be singulated from the top of the stack and fed into the
scanner. The feeder will continue to pull the top page from the stack until the
last page is fed.
When the feeder detects a stack of paper, the conveyor will stop to allow for
the stack to pass through and will continue when the entire stack is fed. You
can place more stacks on the conveyor when it stops, but keep in mind that the
conveyor will only stop when the feeder encounters a stack.
Note: The conveyor operates differently depending on the Feed Mode job
parameter setting: Normal, Stack, Passive. Stack feeding can be accom-
plished in either Stack or Normal modes. Height sensors come into effect
in Stack mode as well.
Since the feeder pulls from the top of the stack, the lead sheet in the stack
must be the first to reach the feeder. If the bottom piece reaches the feeder
first, a paper misfeed is likely to occur. There are techniques for learning to
drop packets of paper consistently and effectively. The items do not have to be
perfectly aligned as long as the lead sheet is the top sheet. Review these
techniques with your FalconV Administrator or your OPEX Technician or Sales
Engineer.