Omron Sysmac CP1H, Руководство по эксплуатации

Страница: 316 / 810

282
Pulse Outputs Section 5-3
ACCELERATION
CONTROL: ACC(888) Use ACC(888) to set the target frequency and acceleration and deceleration
rate and output pulses with acceleration and deceleration. (Acceleration rate
is the same as the deceleration rate.)
Either independent mode positioning or constant mode speed control is possi-
ble when used in combination with PULS(886). ACC(888) can also be exe-
cuted during pulse output to change the target frequency or acceleration/
deceleration rate, enabling smooth (sloped) speed changes.
F First pulse frequency
word F and F+1 contain the pulse frequency setting, in units of
1 Hz. (F contains the rightmost 4 digits and F+1 contains
the leftmost 4 digits.)
X/XA CPU Units:
Unit version 1.1 and later:
• Pulse outputs 0 to 3:
00000000 to 000186A0 hex (0 Hz to 100 kHz)
Unit version 1.0 and earlier:
• Pulse outputs 0 and 1:
00000000 to 000186A0 hex (0 Hz to 100 kHz)
• Pulse outputs 2 and 3:
00000000 to 00007530 hex (0 Hz to 30 kHz)
Y CPU Units:
• Pulse outputs 0 and 1:
00000000 to 000F4240 hex (0 Hz to 1 MHz)
• Pulse outputs 2 and 3:
00000000 to 000186A0 hex (0 Hz to 100 kHz)
Operand Contents
Operand Contents
P Port specifier #0000: Pulse output 0
#0001: Pulse output 1
#0002: Pulse output 2
#0003: Pulse output 3
M Output
mode Bits 0 to 3 Mode
0 hex: Continuous
1 hex: Independent
Bits 4 to 7 Direction
0 hex: CW
1 hex: CCW
Bits 8 to 11 Pulse output method (See note.)
0 hex: CW/CCW
1 hex: Pulse + direction
Bits 12 to 15 Not used. (Always 0 hex.)
ACC(888)
P
M
S
P: Port specifier
M: Output mode
S: First word of settings tab