Omron Sysmac CP1H, Руководство по эксплуатации

Страница: 480 / 810

446
Temperature Sensor Units Section 7-5
Setting Temperature Ranges
Note (1) Always turn OFF the power supply before setting the temperature range.
(2) Never touch the DIP switch or rotary switch during Temperature Sensor
Unit operation. Static electricity may cause operating errors.
The Temperature Sensor Unit’s DIP switch and rotary switch are used to set
the temperature unit, to select 2-decimal-place Mode is to be used, and to set
the temperature input range.
DIP Switch Settings
The DIP switch is used to set the temperature unit (
°
C or
°
F) and the number
of decimal places used.
Note For details on 2-decimal-place Mode, refer to Two-decimal-place Mode on
page 453.
Rotary Switch Setting
!Caution
Set the temperature range according to the type of temperature sensor con-
nected to the Unit. Temperature data will not be converted correctly if the tem-
perature range does not match the sensor.
!Caution
Do not set the temperature range to any values other than those for which
temperature ranges are given in the following table. An incorrect setting may
cause operating errors.
The rotary switch is used to set the temperature range.
SW1 Setting
1 Temperature unit OFF
°
C
ON
°
F
2 Number of decimal
places used (See note.)
(0.01 expression) OFF Normal (0 or 1 digit after the decimal
point, depending on the input range)
ON 2-decimal-place Mode
Temperature input terminals
DIP Switch
Used to set the temperature
unit and the number of
decimal places used. Rotary Switch
Used to set the
temperature input range.
ON
1 2