![background image](http://html1.mh-extra.com/html/omron/sysmac-c500-nc222-e/sysmac-c500-nc222-e_operation-manual_742438108.webp)
100
4.
The origin is established at the first phase Z pulse after the trailing edge
of the origin input.
0
Speed
Search direction
Time
CCWLS
CWLS
Origin input
Origin search high speed
Origin search low speed
Start position
Phase Z
Pulses in
error
counter
at CWLS
7-3
Origin Compensation
The encoder phase Z position may not always designate the mechanical ori-
gin as desired. Sometimes the origin may be preferred a few pulses CW or
CCW from the phase Z pulse. In order to correct the origin’s position, set the
origin compensation parameter (addresses 414 for the X axis and 814 for the
Y axis) with the amount of compensation desired. Once the parameter is set,
the origin is established according to the desired compensation from the
phase Z pulse detected during origin search.
ÉÉ
ÉÉ
ÉÉÉÉ
ÉÉÉÉ
Origin compensation
parameter contents
Speed
High origin search speed
Time
0
Low origin search speed
Phase Z detection point
Origin input
Phase Z
Origin Compensation
Section 7-3
Содержание SYSMAC C500-NC222-E
