Omron R6YXG500, Руководство по установке

Страница: 197 / 330

3
Robot settings
3-21
■
Changing the X-axis origin position
The X-axis origin position can be changed to any position in the range from the front position of the X-axis arm base to
a maximum of 120° clockwise and counterclockwise at 30° intervals, by changing the positions of the dog and the
mounting bolt for the X-axis speed reduction unit as shown below.
CAUTION
If the origin position has been changed, then the absolute reset must be performed, the machine reference must be adjusted, and the
standard coordinate and point data must be reset.
Dog and mounting bolt for X-axis speed reduction unit
Dog
Mounting bolt for X-axis speed reduction unit
CAUTION
For the wall-mount and inverse wall-mount models (R6YXGS500, R6YXGS600, R6YXGS700, R6YXGS800, R6YXGS900 and
R6YXGS1000), the X-axis origin position can be changed in the same manner as the standard model. However, the cover removal work
may involve risk. So, contact your distributor before changing the X-axis origin position.
X-axis origin position adjustable range
Factory-preset
X-axis origin position
X-axis origin position adjustable range
120°
90°
60°
30°
120°
90°
60°
30°
The following describes how to change the X-axis origin position, for example, to a position 90° counterclockwise.
Prepare the tools listed below.
• Hex wrench set • Torque wrench • phillips screwdriver • Hex bit • phillips screwdriver bit
1
Turn on the controller.
Check that no one is inside the safety enclosure, and
then turn on the controller.
2
Perform the absolute reset.
Perform the absolute reset from outside the safety
enclosure.
For details about how to perform the absolute reset,
see "2.3 Absolute reset procedures".