![background image](http://html1.mh-extra.com/html/omron/c200h-cp114/c200h-cp114_operation-manual_742477035.webp)
21
Data Setting and Monitoring
Section 3-3
9.
With the Up and Down Keys, select either “
” or “
”.
10. Press the Return Key to enter the selection.
Repeat (6) through (10) for each cam number.
11. Press the Reverse Key to restore the blinking display to its previous lit con-
dition.
When the mode number is blinking, press the Reverse Key a second time
to restore the blinking display to its previous lit condition and complete the
setting operation.
Setting the Number of Revolutions Required for a Single Process (Mode 5)
1,2,3...
1.
Set the RUN/PRG selector switch to PRG.
If PRG is already selected, then proceed directly to (2).
2.
Press the Return Key, the Up Key, or the Down Key to cause the Mode 5
indicator to blink.
Press the Return Key, the Up Key, or the Down Key.
The MODE indicator will blink.
Press either the Up Key or the Down Key until “5” is displayed.
3.
Press the Return Key to cause the decimal point to blink.
4.
Use the Up Key or the Down Key to set the position of the decimal point.
This setting also sets the decimal point position for the monitoring of the
number of process execution cycles (see next page). When making this
setting, take into account the maximum number of digits to be displayed to
the left of the decimal point.
Example:
If the set value for the monitoring of the number of process ex-
ecution cycles is 52.0, and if the decimal point position is set
at 0.00, then 2.00 will be displayed. Therefore, in this case, the
decimal point position should be set at 00.0.
5.
Press the Return Key to cause the numerals to blink.
6.
Use the Up Key or the Down Key to increment or decrement the set value.
It is possible to change the values rapidly by holding down the Key.
If either the decimal point or the set value is blinking, then press the Clear
Key twice. “
” will then be displayed.
7.
Press the Return Key to enter the set value.
8.
Press the Reverse Key to restore blinking items to their previous lit condi-
tion.
Number of revolutions required
for a single process
Mode no.
Содержание C200H-CP114
