Mounting
2.1
MOUNTING THE CONTROLLER
Once a suitable location has been found, use the following steps to mount the unit:
1. Unscrew the 4 case screws on the box, and remove the lid.
2. The mounting holes for the unit are located inside the box, near to each corner - see
diagram below.
3. The mounting screws that are provided should be suitable for most surfaces (such as
wood / fibreglass). Mark out the required mounting hole centres and drill pilot holes
as required – being careful to check for obstructions such as cables / pipes behind the
area being drilled.
4. Screw the unit to the surface using the screws provided.
Never use power tools. Hand tighten only!
2 0 1 9 I N S TA L L & O P E R AT I O N M A N U A L
CONTROLLER
KITS
6
