5.4
DMX
1. Loosen the cable gland, feed the cable end through and connect as follows:
(BLACK) DMX GROUND
(BROWN) DMX -
(YELLOW) DMX +
(RED) POWER SW
SHIELD
5.5
AUDIO INPUT
3.5mm stereo input jack socket input:
AUDIO INPUT
For best results use the ‘line-out’ connection from an audio source, rather than a
headphone outlet, as levels should not change with volume.
If required, audio level can be manually adjusted using a small screwdriver through
the top plate of the unit (box lid needs to be removed). However we generally
advise to leave this on maximum setting, and only adjust if required.
1. Undo the large (M20) cable gland, and thread the audio cable (not supplied)
through the gland and gland nut. Using the suppled split grommet, place over the
cable and re-assemble the gland. Do not tighten at this stage.
2. Plug in the jack to the jack socket and re-tighten the cable gland.
5.6
SWITCH INPUTS (OPTIONAL):
1. Remove the blanking plug in the side of the box.
2. Obtain a suitable M16 cable gland (not supplied) and fit into the hole the blanking
plug was removed from
3. Connect a switch between the required switch output (Note that only SW1
implemented at this stage), and the switch ground connection:
Installation (X Series)
2 0 1 9 I N S TA L L & O P E R AT I O N M A N U A L
CONTROLLER
KITS
20
