If required, audio level can be manually adjusted using a small screwdriver through
the top plate of the unit (box lid needs to be removed). However we generally
advise to leave this on maximum setting, and only adjust if required.
1. Undo the large (M20) cable gland, and thread the audio cable (not supplied)
through the gland and gland nut. Using the suppled split grommet, place over the
cable and re-assemble the gland. Do not tighten at this stage.
2. Plug in the jack to the jack socket
3. Tighten the cable gland.
3.6
SWITCH INPUTS (OPTIONAL):
1. Remove the blanking plug in the side of the box.
2. Obtain a suitable M16 cable gland (not supplied) and fit into the hole the blanking
plug was removed from
3. Connect a switch between the required switch output (Note that only SW1
implemented at this stage), and the switch ground connection:
3.9
FINALISE YOUR INSTALLATION (EXPLORE E6):
1. Plug the Terminator to the Control Out of the last light. See diagram on P7.
Always check the connections and test the system BEFORE the boat goes back
into the water. Typical OceanLED light installs require the boat to be hauled out
of the water to replace light units
The DMX standard recommends a maximum of 32 devices to be connected in
one chain. If installation requires more lights than this, please contact
OceanLED for advice.
Installation (Explore Series)
!
11
2 0 1 9 I N S TA L L & O P E R AT I O N M A N U A L
CONTROLLER
KITS
