OceanDMX WiFi Controller
Problem
Check
Cause
Fix
Unit is not
powering up
Check that
the unit is
connected to
a suitable DC
power supply
Poor electrical
connection
Connect the unit
to a suitable DC
power supply
Check if the fuse
is blown
Replace the
fuse.
If fuse keeps
blowing, then
there is a short
circuit in the
unit that must
be traced and
rectified. If no
external short
can be located,
contact your
local OceanLED
representative.
Check that the
wiring polarity is
correct
Polarity
Incorrect
Check the wiring
polarity.
Check that the
voltage applied
to the unit is not
below 9 Volts
Low Voltage
The voltage
needs to be with
9 Volts and 36
Volts
After the
diagnostic LEDs
flash 3 times
(during power
up), the green
LED is solid for
4-6 seconds
and this keeps
repeating
(unit is not
transmitting
DMX data –
green LED not
flashing)
Check that the
voltage applied
to the unit is not
below 9 Volts.
Low Voltage.
The voltage
needs to be with
9 Volts and 36
Volts
Switch the unit
OFF and ON
while pressing
the Reset button.
After power up,
release the Reset
button.
If this issue
persists, please
contact your
Ocean LED
representative.
8
Troubleshooting
31
2 0 1 9 I N S TA L L & O P E R AT I O N M A N U A L
CONTROLLER
KITS
