If required, audio level can be manually adjusted using a small screwdriver through
the top plate of the unit (box lid needs to be removed). However we generally
advise to leave this on maximum setting, and only adjust if required.
1. Undo the large (M20) cable gland, and thread the audio cable (not supplied)
through the gland and gland nut. Using the suppled split grommet, place over the
cable and re-assemble the gland. Do not tighten at this stage.
2. Plug in the jack to the jack socket
3. Tighten the cable gland.
4.6
SWITCH INPUTS (OPTIONAL):
1. Remove the blanking plug in the side of the box.
2. Obtain a suitable M16 cable gland (not supplied) and fit into the hole the blanking
plug was removed from
3. Connect a switch between the required switch output (Note that only SW1
implemented at this stage), and the switch ground connection:
4.8
DRIVER CONNECTIONS (PRO SERIES):
1.
For instructions on wiring your Pro Series HD drivers, please refer to the Pro Series
installation manual.
4.9
FINALISE YOUR INSTALLATION (PRO SERIES COLOURS):
Always check the connections and test the system BEFORE the boat goes back
into the water. Typical OceanLED light installs require the boat to be hauled out
of the water to replace light units.
The DMX standard recommends a maximum of 32 devices to be connected in
one chain. If installation requires more lights than this, please contact OceanLED
for advice.
1. Connect the DMX controller DMX output cable to the DMX input of the first driver
box. The DMX output of this box should be connected to the input of the next, and
so on up to the last driver in the chain.
2. Fit the supplied terminator to the output of the last driver box. See example
diagram on P12.
Installation (Pro Series)
!
2 0 1 9 I N S TA L L & O P E R AT I O N M A N U A L
CONTROLLER
KITS
16
