NOVUS AUTOMATION
13/48
6
PARAMETER CYCLES
The configuration parameters are clustered in affinity groups, called parameter cycles. The 10 parameter cycles are:
CYCLE
ACCESS
1 - Primary Cycle:
In this cycle are the screens for viewing the psychrometric variables.
Unrestricted access
2 -
0vt1
Cycle:
In this cycle are the configuration parameters of the transmission 1 output.
Enables the protection
mode of these cycles
3 -
0vt2
Cycle:
In this cycle are the configuration parameters of the transmission 2 output.
4 -
ALM1
Cycle:
In this cycle are the configuration parameters of the alarm 1 output.
5 -
ALM2
Cycle:
In this cycle are the configuration parameters of the alarm 2 output.
6 -
Bv22
Cycle:
In this cycle are the configuration parameters of the buzzer.
7 -
1
k
M
Cycle:
In this cycle are the HMI configuration parameters.
8 -
DIAG
Cycle:
In this cycle are the parameters for forcing values of temperature, relative humidity and transmission outputs, alarm
and buzzer.
9 -
(0m
Cycle:
In this cycle you can configure parameters related to RS485 Modbus communication.
10 -
(nfg
Cycle:
You must enter the device password to access the parameters in this cycle. The parameters allow the selection of the
measurement units, the adjustment of the atmospheric pressure, besides the offsets and the digital filters for the
sensor readings. You also can enable the protection of the configuration parameters and change the password.
11 - Information Cycle:
In this cycle are displayed the serial number (
sn
) and the firmware version (
firm
) of the device.
Table 02
– Parameter cycles
