
INITIAL START-UP
PAGE
|
40
Initial start-up
The Initial start-up section includes subsections:
•
Status LEDs
•
With a UC-2000 Controller
•
Without a UC-2000 Controller
Status LEDs
Three status LEDs on the rear of the OEM v30 laser provide a visual indication of operating status. A green
PWR LED illuminates when DC power is applied to the laser. The yellow RDY LED indicates that a Laser Enable
signal has been applied and lasing will begin once a PWM
Command signal is received. The LASE LED
illuminates red to indicate that the PWM Command signal is sufficient to induce laser output
.
Warning: Serious Personal Injury
OEM v30 SxG lasers do not include a five-second delay function. This means a tickle signal can be
applied immediately after the Laser Enable input is activated, effectively eliminating the delay on
laser power-up or interlock activation.
As with other laser safety requirements, the OEM or system integrator is solely responsible for
designing the system to incorporate a five-second delay and any other controls required by relevant
laser safety standards for Class 4 laser devices.
Caution: Possible Equipment Damage
Remove the aperture seal before firing the laser. The self-adhesive seal is installed to prevent dust
from entering the laser housing during shipment and installation and must be removed before
operation.
Danger: Serious Personal Injury
This Class IV laser product emits invisible infrared laser radiation in the 10.6
μ
m CO2 wavelength
band. Since direct or diffuse laser radiation can inflict severe corneal injuries, always wear eye
protection when in the same area as an exposed laser beam. Do not allow the laser beam to contact a
person. This product emits an invisible laser beam that is capable of seriously burning human tissue.
Always be aware of the beam’s path and always use a beam block while testing.
Содержание v30
