Novanta v30, Руководство пользователя, Страница: 27 / 101

MOUNTING PAGE | 27
Mounting
The OEM v30 base plate is designed so the laser is easily mounted using three 1/4–20 UNC or M6 × 1 ISO
fasteners. Three ball bearing “feet” pressed into the base plate eliminate any distortion of the laser tube
caused by variations in the flatness of the mounting surface. Refer to OEM v30 package outline drawings
in the Technical Reference chapter for mounting locations and dimensions.
Important Note: To prevent distortion of the tube, you must fasten the v30 base plate directly to
your mounting surface.
Mounting bolts must not extend further than 6.0 mm (0.24") into the v30 base plate.
Figure 1-2 OEM v30 mounting locations (1/4–20 fastener locations shown)
To fasten the OEM v30 laser to your mounting surface, perform the following steps:
1 Refer to the appropriate v30 outline & mounting drawing and drill three holes into your mounting
surface that correspond to either the UNC or metric hole pattern.
2 Place the v30 laser on the mounting surface so that the threaded holes in the base plate line up
with the holes in your mounting surface as shown in Figure 1-2.
3 Insert three M6 × 1 ISO or 1/4–20 UNC cap screws through the mounting surface into the
threaded holes of the v30 base plate. Turn the screws by hand until the threads engage.
4 Evenly tighten all three cap screws to a maximum torque of 6.1 N m (54 in lb.)
Caution: Possible Equipment Damage
NOVANTA does not recommend mounting lasers in a vertical “head-down” or “tail-down”
orientation. If you must mount your laser in this manner, please contact the factory for limitations as
vertical orientation increases the risk of damage to the laser’s output optic.