Nordson Vulcan Jet, Руководство пользователя по изделию

Страница: 134 / 172

Maintenance 7-18
Part 1126187_05
E
2021 Nordson Corporation
Installing the Piezo Actuator
To install the piezo actuator, do the following steps.
1. Obtain a new piezo actuator (6).
2. Use a 2.5 mm hex driver to tighten the two screws (4) that hold the slide
block (5) to the piezo actuator (6). Torque the screws to a value of
8-9 in-lb.
2
3
1
4
4
5
6
Figure 7-16 Piezo Actuator Assembly
3. Use a 2.5 mm hex wrench to tighten the two screws (2) that hold the air
flush heat exchanger (3) to the slide block (5). Torque the screws to a
value of 8-9 in-lb.
4. Slide the the piezo actuator (2) down into the frame plates (1), along with
the slide block (3) and air flush heat exchanger (4).
1
3
2
1
5
4
Figure 7-17 Piezo Actuator Assembly
5. Slide the aluminum block (5), onto the air fitting on the air flush heat
exchanger (4).
6. Place the applicator on a table as shown in Figure 7-18.