Nordson HORIZON 200, Руководство по эксплуатации продукта

Страница: 36 / 124

Operation
3-10
Part 106913 − 04
E 2018 Nordson Corporation
Old Color Removal
(contd)
10. Move the transfer hoses (3), air tubing, and cables off the floor and out
of the way so they will not be damaged when you remove the color
module.
11. Pull the color module, feed hopper, and sieve assembly from under the
base, using the handle (9) provided. Move the assembly to a storage
area and install a storage cover over the color module.
12. With a vacuum and soft brush, clean the powder from the:
S
edges of the floor inlet
S
hook and loop tape strips
S
underside of the floor
S
area where the color module seals against the fan compartment
13. Inspect the fan compartment. If there is a large amount of powder in the
fan compartment, check the filter cartridge media and gaskets for
damage. Clean the fan compartment and check the final filters.
New Color Installation
1. Remove the storage cover from the new color module. Inspect the
D-gasket and replace it if it is damaged.
2. See Figure 3-6. Position the new color module under the base, aligning
the top of the color module with the floor inlet and the D-gasket with the
fan compartment opening.
3. Check the gap between the base floor and the color module. Maintain
the gap at 19 mm (0.75 in.). Use the color-module leveling screws to
raise or lower the color module.
NOTE:
If the limit switch (Figure 3-2, item 1) is not closed when the color
module is clamped to the fan compartment you will not be able to start the
exhaust fan. If it does not close, adjust the switch position. Loosen the
mounting screws and slide the switch forward or back.
4. Hook the clamping straps to the base. Tighten the ratchets (1) to
compress the D-gasket. The gap between the color module and the fan
compartment should be 19 mm (0.75 in.) wide when the D-gasket is
properly compressed.
5. Install the skirt seal over the joint between the base floor and the color
module. Line up the skirt corners with the inlet corners and smooth
down the skirt to press the Velcro strips together.
6. Connect the color module quick-disconnect plate (2) to the base plate.
7. Connect the 10-tube connectors (4) to the receptacles on the feed
hopper.
8. Connect the color-module ground strap to the base.
9. Plug the sieve electrical cables into the junction box receptacles (10).
10. Insert the level sensor (6) into the mounting well until it bottoms out,
then pull it back about 3 mm (0.125 in.) and tighten the retainer screws.