Nordson HORIZON 200, Руководство по эксплуатации продукта

Страница: 122 / 124

Specifications
9-2
Part 106913 − 04
E 2018 Nordson Corporation
Utilities
Primary Electrical Service:
230, 460, or 575 Vac. The customer must
install a fused disconnect switch with lock-out capability, wired in
accordance with the National Electric Code, NFPA-70.
Compressed Air Supply:
The air supply line must be 38-mm (1.5-in.) ID
minimum. Supply air pressure must be 5.5 − 7 bar (80 − 100 psi). The
pressure dewpoint must be 3.3 _ C (38 _ F) or less at 7 bar (100 psi). The air
temperature must be less than 37.8 _ C (100 _ F).
Normal Design Standards
Systems are custom-designed to each customer’s requirements, so some
may deviate from these design standards. Contact your Nordson
representative if you need more information about the design of your booth.
End Openings:
152-mm (6-in.) clearance on all four sides of the largest
part.
Part Hanger Keyhole Slot:
305-mm (12-in.) high.
Cross Drafts:
No more than 18 m/min (60 fpm).
Average Face Velocity:
30 m/min (100 fpm) (minimum) through all
openings in the booth enclosure.
Temperature of Parts Entering Booth:
No more than 49 _ C (120 _ F).
Powder:
Use commercially available powder coatings. Note that the
characteristics and properties of a powder coating can affect system
operation. Powder coatings generally have an average particle size of
25 − 35 microns, with no more than 10% of the total being less than
15 microns. When the percentage of particles less than 15 microns
exceeds 10% of the total, the filter media can get clogged.
Cartridge Filters:
Cartridge filters are considered wear items. The
variables affecting the life expectancy of a cartridge filter include
S
type of coating material
S
particle size distribution
S
humidity and temperature of the spray room air
S
hours of operation
S
dew point and cleanliness of the compressed air supply
S
pressure and frequency of air pulses used to clean the filters
S
transfer efficiency