Nordson HORIZON 200, Руководство по эксплуатации продукта

Страница: 27 / 124

Operation
3-1
Part 106913 − 04
E
2018 Nordson Corporation
Section 3
Operation
WARNING:
Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
New System Startup
WARNING:
Wear an approved respirator or dust mask, and safety glasses
or goggles when handling powder. Avoid getting powder on your skin.
Wash powder off with soap and water only.
Use these procedures to prepare your Horizon powder coating system for
production. Setup and operation of powder application equipment, gun
movers, and advanced control systems are covered in separate manuals.
Use the charts at the end of this section to record your booth and spray gun
settings. Make extra copies of the charts as needed.
Transfer Pump and Pulse Valve Timer Settings
WARNING:
Even with the electrical-panel disconnect switch in the off
position, the terminals at the top of the switch are still live. Do not touch
them. Failure to observe this warning could result in serious injury or death.
1. See Figure 3-1. Disconnect the system electrical power and open the
system electrical panel.
2. Set the transfer pump and pulse valve timers then close the electrical
panel.
Transfer pump delay timer (1): 60 seconds
Pulse valve off timer (2):
90 seconds
Pulse valve on timer (3): 0.07 seconds