Nordson HORIZON 200, Руководство по эксплуатации продукта

Страница: 40 / 124

Operation
3-14
Part 106913 − 04
E 2018 Nordson Corporation
New Color Module with Portable Feed Hopper
1. Complete all the steps under Old Color Removal in the
Reclaim-to-Reclaim procedure.
2. Perform steps 1 through 5 under New Color Installation in the
Reclaim-to-Reclaim procedure.
3. See Figure 3-8. Position the portable feed hopper (3) so you can
connect the feed hoses (5) from the powder pumps (2) to the spray
guns.
4. Connect the 10-tube connectors (4) to the receptacles on the feed
hopper.
5. Install a vent hose (1) between the feed hopper and a color-module vent
stub.
6. Connect the transfer hoses to a scrap drum (6). Connect a vent hose
from the scrap drum to a color-module vent stub.
7. Connect the feed-hopper ground strap to the booth base. Make sure all
other equipment is connected to ground.
8. Install new feed hoses (5) between the powder pumps and the spray
guns, or use hoses that have already been used with the new color.
9. Set the transfer-pump selector switch to MANUAL or OFF.
a. Set the switch to MANUAL to continuously pump the collected
powder from the color module to the scrap drum.
b. Set the switch to OFF if you want to wait until you are done spraying
before you pump the powder into the scrap drum.
10. Perform the Startup after Color Change procedure on page 3-15.