Nitto Seiko FEEDMAT FM5000 Series, Инструкция по эксплуатации

Страница: 81 / 84

Operation Box for Multi Spindle Screw Driving Machine 6. Appendix
45
6.2 Touch panel backup battery replacement procedure
The touch panel HG1F-SB22YF-S (IDEC) mounted to this machine incorporates a backup battery to store
internal backup data (log data, keep register and keep relay), and clock data.
When a message prompting battery replacement is displayed, replace the backup battery by following the
procedure below:
If a message indicating “battery is almost exhausted” is displayed, replace the battery immediately.
Otherwise, backup data and clock data may be lost.
(Replacement procedure)
1. Loosen the screws on both sides of the operation box case. (8 places in total)
You can access the back of the touch panel by removing the screws from the side covers, as
shown below:
(Right side) (Left side)
2. Remove the battery cover from the back of the touch panel.
(Touch panel rear view)
3. Turn ON the power switch once, and after elapse of approx. one minute, turn OFF the power switch.
4. Insert a slotted screwdriver into the position shown in the figure below, and remove the battery.
* In this step, the battery may jump out. Use caution.
(When locked) (When unlocked)
Screwdriver