Nitto Seiko FEEDMAT FM5000 Series, Инструкция по эксплуатации

Страница: 63 / 84

Operation Box for Multi Spindle Screw Driving Machine 3. Setup function
27
3.4 Machine setup function
This function is used to set parameters to meet the machine specifications.
Main functions

Enabling setup and change of machine parameters

Enabling change of selection of screw feed function, selection of tightening check function, etc.

Enabling setup and change of each timer

Enabling setup and change of machine structure

Language change function (Japanese/English)
This function can change operating conditions depending on the settings that meet the machine
specifications. With these settings, you can easily change the machine conditions.
In principle, settings that meet the machine specifications are required. For example, in case of a fault of an
axis, you can take an emergency action to operate the machine by changing the axis to be used.
Note that such an emergency action may change product installation conditions. Such an action should be
conducted under agreement and responsibility of system administrator.
To change the display to the MACHINE SETUP screen, follow the procedure below:

SETUP screen
Touch the “MACHINE SETUP” switch on the SETUP screen as shown above, to change the display to the
MACHINE SETUP screen.

MACHINE SETUP 1/5 screen

[1. SCREW FEED]
This item is used to enable or disable screw feed operation. For the machine with a screw
feeder, select “ENABLE”. If a screw feeder is not provided, or to execute re-tightening
operation, select “DISABLE”.

[2. FEED CHECK]
This item is used to enable or disable screw feed detection. As an option, a screw feed
detection sensor may be provided for the machine. In this case, screw feed detection is
enabled if the setting of this item is “ENABLE”. Under this setting, if screw feed cannot be
detected during screw feed operation, the fault is output and the machine will be stopped
on the spot.