Nitto Seiko FEEDMAT FM5000 Series, Инструкция по эксплуатации

Страница: 78 / 84

Operation Box for Multi Spindle Screw Driving Machine 6. Appendix
42
[List of cycle stop faults]
Name of fault Memory Description
(Cycle stop fault 1) M410
SCREW FEED FAULT 1 M411
When screw feed operation is not normally completed
with Axis 1, this fault occurs.
To detect a screw feed fault, the optional screw feed check
sensor is required.
If the setting of [2. FEED CHECK] is [DISABLE] in
machine setup, the above condition is not regarded as a
fault.
SCREW FEED FAULT 2 M412
When screw feed operation is not normally completed
with Axis 2, this fault occurs.
To detect a screw feed fault, the optional screw feed check
sensor is required.
If the setting of [2. FEED CHECK] is [DISABLE] in
machine setup, the above condition is not regarded as a
fault.
SCREW FEED FAULT 3 M413
When screw feed operation is not normally completed
with Axis 3, this fault occurs.
To detect a screw feed fault, the optional screw feed check
sensor is required.
If the setting of [2. FEED CHECK] is [DISABLE] in
machine setup, the above condition is not regarded as a
fault.
SCREW FEED FAULT 4 M414
When screw feed operation is not normally completed
with Axis 4, this fault occurs.
To detect a screw feed fault, the optional screw feed check
sensor is required.
If the setting of [2. FEED CHECK] is [DISABLE] in
machine setup, the above condition is not regarded as a
fault.
(Cycle stop fault 6) M415
(Cycle stop fault 7) M416
(Cycle stop fault 8) M417
(Cycle stop fault 9) M418
(Cycle stop fault 10) M419
(Cycle stop fault 11) M420
TORQUE FAULT 1 M421
If tightening operation is not completed at proper
tightening torque with Axis 1, this fault occurs. The
following two causes can be considered:

Driver operation is completed in NG condition, or alarm

Tightening time over
If tightening time exceeds the time over setting of [9.
FASTENING TIME] in machine setup, this fault occurs.
TORQUE FAULT 2 M422
If tightening operation is not completed at proper
tightening torque with Axis 2, this fault occurs. The
following two causes can be considered:

Driver operation is completed in NG condition, or alarm

Tightening time over
If tightening time exceeds the time over setting of [9.
FASTENING TIME] in machine setup, this fault occurs.