Nitto Seiko FEEDMAT FM5000 Series, Инструкция по эксплуатации

Страница: 79 / 84

Operation Box for Multi Spindle Screw Driving Machine 6. Appendix
43
Name of fault Memory Description
TORQUE FAULT 3 M423
If tightening operation is not completed at proper
tightening torque with Axis 3, this fault occurs. The
following two causes can be considered:

Driver operation is completed in NG condition, or alarm

Tightening time over
If tightening time exceeds the time over setting of [9.
FASTENING TIME] in machine setup, this fault occurs.
TORQUE FAULT 4 M424
If tightening operation is not completed at proper
tightening torque with Axis 4, this fault occurs. The
following two causes can be considered:

Driver operation is completed in NG condition, or alarm

Tightening time over
If tightening time exceeds the time over setting of [9.
FASTENING TIME] in machine setup, this fault occurs.
(Cycle stop fault 16) M425
(Cycle stop fault 17) M426
(Cycle stop fault 18) M427
(Cycle stop fault 19) M428
(Cycle stop fault 20) M429
(Cycle stop fault 21) M430
HEIGHT FAULT 1 M431
If tightening operation is not completed at proper
tightening height with Axis 1, this fault occurs.
If the setting of [4. HEIGHT CHECK] is [DISABLE] in
machine setup, the above condition is not regarded as a
fault.
HEIGHT FAULT 2 M432
If tightening operation is not completed at proper
tightening height with Axis 2, this fault occurs.
If the setting of [4. HEIGHT CHECK] is [DISABLE] in
machine setup, the above condition is not regarded as a
fault.
HEIGHT FAULT 3 M433
If tightening operation is not completed at proper
tightening height with Axis 3, this fault occurs.
If the setting of [4. HEIGHT CHECK] is [DISABLE] in
machine setup, the above condition is not regarded as a
fault.
HEIGHT FAULT 4 M434
If tightening operation is not completed at proper
tightening height with Axis 4, this fault occurs.
If the setting of [4. HEIGHT CHECK] is [DISABLE] in
machine setup, the above condition is not regarded as a
fault.
(Cycle stop fault 26) M435
(Cycle stop fault 27) M436
(Cycle stop fault 28) M437
(Cycle stop fault 29) M438
(Cycle stop fault 30) M439
(Cycle stop fault 31) M440