Nitto Seiko FEEDMAT FM5000 Series, Инструкция по эксплуатации

Страница: 66 / 84

Operation Box for Multi Spindle Screw Driving Machine 3. Setup function
30

MACHINE SETUP 3/5 screen

Numeric keys

[7. AXIS SLCT]
This item is used to select tightening axes of this machine. Normally (as the
factory-setting), all axes of the machine should be set as “ON”. However, in case where a
fault occurs with any of the axes, for example, tightening operation and judgment for the
relevant axis are disabled by setting the axis as “OFF”. This function serves as an
emergency action to operate the machine.

[8. FEED TIME]
This item is used to set a screw feed time. Touching the numerical display field (gray area)
displays numeric keys. Arbitrary setting is enabled. (Setting range: 0.1 to 9.9 s)
When the machine is equipped with a screw feeder, and the setting of “1. SCREW FEED” is
“ENABLE”, this item can be set. When the setting of “3. FEED CHECK” is “ENABLE”, and
the screw feed detection sensor does not turn ON within the time of this setting, a screw
feed fault is output.

[9. FASTENING TIME]
This item is used to set a tightening failure detection wait time. Touching the numerical
display field (gray area) displays numeric keys.
Arbitrary setting is enabled. (Setting range: 0.1 to 99.9 s)
If the torque-up signal from the driver controller is not input within the time of this setting,
a tightening torque fault is output.

[RET]
This switch is used to change the display to the SETUP screen.

[

], [

]
These switches are used to change machine setup items.