Nitto Seiko FEEDMAT FM5000 Series, Инструкция по эксплуатации

Страница: 80 / 84

Operation Box for Multi Spindle Screw Driving Machine 6. Appendix
44
Name of fault Memory Description
ANGLE FAULT 1 M441
If tightening operation is not completed at proper tightening
angle with Axis 1, this fault occurs.
When the tightening angle is out of the angle setting range of
the driver controller’s parameter, this fault occurs.
If the setting of [6. ANGLE CHECK] is [DISABLE] in
machine setup, the above condition is not regarded as a fault.
ANGLE FAULT 2 M442
If tightening operation is not completed at proper tightening
angle with Axis 2, this fault occurs.
When the tightening angle is out of the angle setting range of
the driver controller’s parameter, this fault occurs.
If the setting of [6. ANGLE CHECK] is [DISABLE] in
machine setup, the above condition is not regarded as a fault.
ANGLE FAULT 3 M443
If tightening operation is not completed at proper tightening
angle with Axis 3, this fault occurs.
When the tightening angle is out of the angle setting range of
the driver controller’s parameter, this fault occurs.
If the setting of [6. ANGLE CHECK] is [DISABLE] in
machine setup, the above condition is not regarded as a fault.
ANGLE FAULT 4 M444
If tightening operation is not completed at proper tightening
angle with Axis 4, this fault occurs.
When the tightening angle is out of the angle setting range of
the driver controller’s parameter, this fault occurs.
If the setting of [6. ANGLE CHECK] is [DISABLE] in
machine setup, the above condition is not regarded as a fault.
(Cycle stop fault 36) M445
(Cycle stop fault 37) M446
(Cycle stop fault 38) M447
(Cycle stop fault 39) M448
(Cycle stop fault 40) M449
(Cycle stop fault 41) M450
Pro. COUNT UP M451
The production counter has reached the preset value of the [4.
PRODUCTION PRESET] parameter on the COUNTER
screen. Reset the [1. GOAL COUNTER].
If [4. PRODUCTION PRESET] is set at “999999”, cycle stop
will not occur.
SHOT COUNT UP M452
The setting of [5. SHOT PRESET] on the COUNTER screen is
“0”.
Set the [5. SHOT PRESET] parameter on the COUNTER
screen again.
If the set value is “999999”, cycle stop will not occur.
FEED COUNT UP M453
The setting of [6. FEED PRESET] on the COUNTER screen is
“0”.
Set the [6. FEED PRESET] parameter on the COUNTER
screen again.
If the set value is “999999”, cycle stop will not occur.