Nitto Seiko FEEDMAT FM5000 Series, Инструкция по эксплуатации

Страница: 77 / 84

Operation Box for Multi Spindle Screw Driving Machine 6. Appendix
41
6. Appendix
6.1 Description of faults
Possible fault conditions of the multi spindle screw driving machine (standard type) are listed below.
* Actual fault conditions may vary depending on the machine being used.
[List of immediate stop faults]
Name of fault Memory Description
CYCLE TIME OVER M400
When one cycle operation time exceeds the set value of
the cycle time over parameter, it is indicated as a fault.
(Immediate stop fault 2) M401
(Immediate stop fault 3) M402
(Immediate stop fault 4) M403
(Immediate stop fault 5) M404
(Immediate stop fault 6) M405
DRIVER ALARM M406
When the driver controller’s system alarm detection
output is detected, it is indicated as a fault.
If this fault occurs, the machine automatically executes
emergency stop operation when the fault is reset.
However, the fault cannot be reset depending on the fault
condition.
For details, refer to the driver controller operation manual.
If the machine is equipped with our KX/NX driver, an
alarm code “A***” is indicated on the display of the
driver controller when the driver alarm is activated.
BEHAVIO ALARM M407
Improper adjustment or malfunction of the cylinder sensor
of the driver up/down unit can be considered. Check the
relevant sensor.
(Immediate stop fault 9) M408
(Immediate stop fault 10) M409