Wheel System, Non-traction
143
Service Manual – Condor
™
EcoFlex
™
, BR 1100/1300 EcoFlex
™
Removal and Installation
Warning! Before removing or reinstalling any machine components, make sure the key switch
is off and the key is removed from the machine.
Install wood blocking or chocks in front of and behind the front drive wheel to
prevent the machine from rolling.
Rear Wheel and Brake Caliper
1
Grip the brake lever
Return Spring
and pull
it back to remove it
from the
Retainer Bolt
mounted to the chassis
(both right and left
wheels)
2
• On the left wheel,
unclip the brake
cable
Clevis Yoke
at the brake arm
and remove it from
the brake arm
mounting hole
• On the right wheel,
remove the
Cotter
Pin
from the
Brake
Linkage Rod
and
disconnect the
Brake Linkage Rod
from the brake arm
mounting hole
3 Loosen the
M10-1.5
x 20mm Hex Screw
holding the
Rear Wheel
to the axle
4
Position a suitable jack underneath the wheel axle and jack up the machine so the wheel is
approximately 1 inch off the floor.
Warning! Place wood blocking under the rear axle as the machine is only being supported by
the jack. This is to prevent any accidents or machine damage when the wheel is off of
the machine.
5 Remove the
M10-1.5 x 20mm Hex Screw
and washer and carefully pull the complete wheel and brake
assembly off the axle
6 If you are replacing the wheel:
a Remove the four
M10-1.5 x 30mm Hex Screws
and nuts holding the
Brake Rotor
to the
Rear Wheel
hub
b Reattach the salvaged
Brake Rotor
to the new
Rear Wheel
hub
Return
Spring
Retainer
Bolt
M10-1.5 x
20mm Hex
Screw
M10-1.5 x
30mm Hex
Screw (4)
Rear
Wheel
Brake
Rotor
Clevis
Yoke
Cotter
Pin
Brake
Linkage
Rod