Scrub System, Disc
105
Service Manual – Condor
™
EcoFlex
™
, BR 1100/1300 EcoFlex
™
10 Remove the four
Hex Nuts
, hex screws and bushings from the left and right front deck supports, then
swing the
Pivot Support Arms
away from their mounting holes
11
Remove the previously-installed wood blocking from underneath the drive discs. Note that this must be
done to get the needed clearance to remove the scrub deck.
12
Carefully slide the complete deck assembly out from underneath the machine from its left side.
Note:
Observe the position of the disconnected lift actuator housing and swing it to the rear to clear
its mount bracket pocket.
Scrub Deck Lift Actuator
Note:
All new replacement actuator motors are not shipped with the lift nut pre-adjusted for any
specific machine model application.
Note:
The scrub deck must be removed to access the top mount bracket on the scrub deck lift motor.
1
Remove the scrub deck by following the steps in the
Scrub Brush Deck
section
2 Locate and remove the upper
Cotter
Hair Pin
from underneath the middle
of the machine
3 Slide the actuator
Mount Pin
from the
housing and frame mounting bracket
holes allowing the motor to drop down
completing its removal
4 Refer to the
Drive Nut Adjustment
section for instructions on how to
install a new drive nut and set the
extended and retracted positions
5 Follow the above steps in reverse
order to install the scrub deck
actuator
Cotter
Hair Pin
Mount
Pin
Mount
Pin
Cotter
Hair Pin