Netopia CLI 874, Справочное руководство CLI

Страница: 174 / 207

3-30 Command Line Interface Commands Reference
cp { name | index } ipsec dead-peer-detection { yes | no }
show cp { name | index } ipsec dead-peer-detection
no cp { name | index } ipsec dead-peer-detection
These commands set, display, or disable the status of dead peer detection for the specified IPsec Phase 2
profile. Dead peer detection counts the outbound packets on a tunnel. If 256 packets go out without a single
packet coming in, the tunnel SAs are expired and a rekey is star ted. Rekeying is first attempted on the previous
Phase 1 SA. If the Phase 1 request times out, then the Phase 1 SA is expired and Phase 1 rekeying is begun
over again.
cp { name | index } ipsec dead-peer-detection ping-address remote_net_IPv4_address
show cp { name | index } ipsec dead-peer-detection ping-address
Note:
These commands are suppor ted beginning with firmware version 8.2
These commands allow you to specify or show what IP destination host address is used to verify whether or not
peer is dead. The IP address
must belong to a tunnel’s remote network (which can be configured as a subnet,
an address range, or an individual host in the IP options menu). The subnet remote network case also disallows
the host par t of the address to be all ones or all zeroes. For example, it is not permitted to set the address to
163.176.0.0 or 163.176.255.255 in a class B network.
cp { name | index } ipsec dead-peer-detection ping-retry 1..65535
show cp { name | index } ipsec dead-peer-detection ping-retry
Note:
These commands are suppor ted beginning with firmware version 8.2
These commands allow you to specify or show the retr y inter val between successive pings (in seconds).
Default is 5 seconds.
IKE/IPSec Connection Profile Commands
cp { name | index } ipsec ip
[ remote
[ members {a.b.c.d | a.b.c.d/n | a.b.c.d e.f.g.h | a.b.c.d-e.f.g.h}]
[ tep a.b.c.d] ]
[ local
[ members {a.b.c.d | a.b.c.d/n | a.b.c.d e.f.g.h | a.b.c.d-e.f.g.h}]
[ tep a.b.c.d] ]
[ via a.b.c.d]
show cp { name | index } ipsec ip
cp { name | index } ipsec sa lifetime { seconds | kbytes } { non-negative-integer | none }
show cp { name | index } ipsec sa lifetime [ { seconds | kbytes } ]
no cp { name | index } ipsec sa lifetime [ { seconds | kbytes } ]