Motorola Netopia® Router CLI Commands 2-105
The default count is 5, and the default timeout is 0.
receive tftp config
[
ser ver-name file-name
]
This command allows you to initiate a configuration file upload from the command line inter face. If the TFTP
ser ver name and config file name were set previously, either by a previous invocation of this command or via
the menu console, then you do not need to supply the ser ver and file name. If the upload is successful, the
router will automatically reboot. If the upload is unsuccessful, in menu mode you can go to:
for information about what went wrong.
receive
tftp
[
wan
{
1
|
2
}]
firmware
[
ser ver-name
[
file-name
]]
This command allows you to receive a firmware file that is located remotely on a TFTP ser ver into the router by
means of a TFTP file transfer.
The
wan 1
and
wan 2
options allow you to specify that the firmware upgrade is to be sent one of the WAN
inter face modules. As with the regular
receive tftp firmware
comand,
ser ver-name
and
file-name
are optional if
they are already specified. If
ser ver-name
or
file-name
are not already specified, it is necessar y to specify
them. (Specifying them with this command will set them.)
send tftp config
[
ser ver-name
file-name
]
The configuration file will be stored on the TFTP ser ver as a binar y image. Note that the file must already exist
on the ser ver and be writable.
show tftp last error
An empty string indicates no error. Other possible return values are: File not found, Unauthorized, Disk Full,
Illegal Operation, Bad TID, File Already Exists, No Such User, and Unknown Error.
show tftp status
The possible return values are: Idle, Reading Firmware, Reading Wanlet Firmware, Reading Config, Writing
Config, Idle, **TRANSFER FAILED**.
receive
xmodem
[
wan
{
1
|
2
}]
firmware
This command allows you to receive a firmware file that is located locally into the router by means of an
XMODEM file transfer.
The
wan 1
and
wan 2
options allow you to specify that the firmware upgrade is to be sent one of the WAN
inter face modules.
The underlying routine that is invoked blocks until either the file has been successfully received or some
condition caused the transfer to abor t. Therefore when this command is invoked the following will appear:
Main
Menu
Statistics &
Logs
Device Event
Histor y
Содержание CLI 874
