Netopia CLI 874, Справочное руководство CLI

Страница: 141 / 207

Motorola Netopia® Router CLI Commands 2-129
IKE Dead Peer Detection
Note:
The commands in this section are suppor ted beginning with Firmware Version 8.5.2.
ike phase1 { name | index } dead-peer-detection enable { yes | no }
show ike phase1 { name | index } dead-peer-detection enable
no ike phase1 { name | index } dead-peer-detection enable
These commands allow you to enable, disable, or show the status of the traffic-based IKE dead peer detection
feature. Traffic-based IKE dead peer detection allows IKE to negotiate RFC3706-based IKE “keepalives” with a
remote security gateway (IKE peer) that suppor ts them. Default is
no (disabled).
show ike phase1 { name | index } dead-peer-detection timeout
ike phase1 { name | index } dead-peer-detection timeout { 3 - 65535 }
These commands allow you to specify or show an inter val, from 3 to 65535 seconds, during which IPSec traffic
may be idle before the router sends a keepalive message to its peer, when
ike phase1 dead-peer-detection
enable is set to yes . Default is 20 (seconds).
IKE Dead Peer Detection Configuration Commands
ike phase1 { name | index } dead-peer-detection enable { yes | no }
show ike phase1 { name | index } dead-peer-detection enable
no ike phase1 { name | index } dead-peer-detection enable
show ike phase1 { name | index } dead-peer-detection timeout
ike phase1 { name | index } dead-peer-detection timeout { 3 - 65535 }