1
Alignment spacers
d. Insert one M5 screw through the front of the cabinet and into the top captured nut in the
mounting rail. Tighten the screw.
e. Insert two M5 screws through the rear of the cabinet and into the captured nuts in the rear
flange in the mounting rail. Tighten the screws.
f. Tighten the adjustment screws on the mounting rail.
g. Repeat these steps to install the second mounting rail.
6. With the help of one other person, slide the rear of the drive tray onto the mounting rails. The rear
edge of the drive tray must fit into the clip on the mounting rail.
The drive tray is correctly aligned when these conditions are met:
•
The mounting holes on the front flanges of the drive tray align with the mounting holes on the
front of the mounting rails. See item 4 in the following figure.
•
The rear edge of the drive tray sheet metal fits into the clip on the mounting rail.
•
The holes in the drive tray sheet metal for the rear hold-down screws align with the captured
nuts in the side of the mounting rails.
Step 6 - Installing the drive trays for the controller-drive tray configurations | 67
Содержание E2760
Страница 2: ......
