NetApp E2760, Руководство по установке

Страница: 105 / 137

Location LED Color On Off
9 Expansion Port 1
Fault LED Amber At least one of the four
PHY is working, but
another PHY cannot
establish the same link to
the device connected to
the Expansion OUT
connector. Normal status.
10 Expansion Port 1
Active LED Green At least one of the four
PHYs in the OUT
connector is working and
a link has been made to
the device connected to
the Expansion connector.
(LED blinks when there
is activity.) The link is not
active.
11 Expansion Port 2
Fault LED Amber At least one of the four
PHY is working, but
another PHY cannot
establish the same link to
the device connected to
the Expansion OUT
connector. Normal status.
12 Expansion Port 2
Active LED Green At least one of the four
PHYs in the OUT
connector is working and
a link has been made to
the device connected to
the Expansion connector.
(LED blinks when there
is activity.) The link is not
active.
1
If LED 1 is on and LED0 is off, the link has auto-negotiated to 8-Gb/s.
2
If LED 0 is on and LED01 is off, the link has auto-negotiated to 4-Gb/s.
3
Does not apply on the two-port version of this host interface card.
* If you have a two-port FC HIC, Ch 5 and Ch 6 are not available. LEDs 5, 6, 7, and 8 are not
on the subplate.
• LEDs on the controller canister – Base-T iSCSI host interface card subplates
Step 10 - Turning on the power and checking for problems in a controller-drive tray configuration | 105