Step 6 - Installing the drive trays for the controller-
drive tray configurations
Things to know - General installation of drive trays
Note:
If you are installing the drive tray in a cabinet with other trays, ensure that the combined
power requirements of the drive tray and the other trays do not exceed the power capacity of your
cabinet.
If you are performing a hot add of a tray to an existing storage array, refer to the
Hardware Cabling
Guide.
•
Special site preparation is not required for any of these drive trays beyond what is normally found
in a computer lab environment.
•
The power supplies meet standard voltage requirements for both domestic and worldwide
operation.
•
Keep as much weight as possible in the bottom half of the cabinet.
Refer to the
Site Preparation Guide for important considerations about cabinet installation.
Procedure - Installing the DE1600 and DE5600 drive trays
About this task
Warning:
(W08) Risk of bodily injury – Two persons are required to safely lift the component.
Warning:
(W05) Risk of bodily injury – If the bottom half of the cabinet is empty, do not install
components in the top half of the cabinet. If the top half of the cabinet is too heavy for the bottom
half, the cabinet might fall and cause bodily injury. Always install a component in the lowest
available position in the cabinet.
You can install the drive tray into an industry-standard cabinet.
This procedure describes how to install the mounting rails into an industry-standard cabinet.
Attention:
Possible hardware damage – To prevent electrostatic discharge damage to the tray,
use proper antistatic protection when handling tray components.
Steps
1. Ensure that the cabinet is in the final location and that you meet the clearance requirements as
shown.
•
DE1600 drive tray – Airflow and clearance requirements
63
Содержание E2760
Страница 2: ......
